Interlogix TruVision NVR 10 - Page 80

78 TruVision NVR 10 User Manual
Figure 18: Layout window
Table 10: Description of the layout window
Submenu name Description
General tab
1.
Video Output Interface
VGA/HDMI monitor is displayed. VGA and HDMI output from the
same port.
2.
Window Segmentation
Select which multiview layout will be default in live view mode.
Default is 1 × 1 multiview layout for the 4-channel, 8-channel, and 16-
channel NVR.
3.
Dwell Time
Set the length of time for which a camera image is displayed on the
selected monitor before moving to the next camera during
sequencing. Default is off (“No switch”).
4.
Enable Audio Out
Check the box to enable/disable audio output. Default is disable.
5.
Event Output
Designates which monitor will be the output to show the event.
Default is HDMI.
6.
Event Full Screen Monitoring
Dwell Time(s)
Set the length of time for which an event appears on the output
monitor before moving to the next camera during sequencing. Default
is 10 seconds.
7.
Alarm Full Screen Monitoring
Dwell Time(s)
Set the length of time for which an alarm appears on the output
monitor before moving to the next camera during
sequencing. Default
is 10 seconds.
To set up the display options:
1. From the menu toolbar, click Display Mode Settings > Layout > General.
2. Specify the desired settings for each of the menu options.
3. Click Apply to save the settings.
4. Click Back to return to live view.
Changing the camera sequence
The cameras are sequenced in numeric order by default. You can change the
sequence order of the cameras for all monitors.