Interlogix TruVision NVR 10 - Page 84

82 TruVision NVR 10 User Manual
The start and end time of daylight saving time (DST) in the year can also be set. DST is
deactivated by default. See Figure 22 below for the Time settings window.
Figure 22: Time and date settings window
Table 13: Description of the time and date settings window
Option Description
1.
Time Zone
Select the time zone of the NVR from the drop-down list.
2.
Date Format
Select the date format from the drop-down list. Default format is MM-DD-
YYYY.
3.
Time Format
Select the time format from the drop-down list. Default format is 24-hour
format.
4.
Display Week
Display the day of the week in the monitor time bar.
Check the box to enable/disable. Default format is Disable.
5.
System Date
Define the system date.
Default date is the current date.
6.
System Time
Define the system time.
Default time is the current time.
7.
Auto DST Adjustment
Define DST is automatically. It depends on the time zone selected.
Default format is Disable.
8.
Enable DST
Manually define DST. If this option is selected, the Auto DST adjustment
option is disabled.
Default format is Disable.
Click the check box to enable or disable daylight savings time (DST).
From
Enter the start date and time for daylight savings.
To
Enter the end date and time for daylight savings.
DST Bias
Set the amount of time to move DST forward from the standard time.
Default is 60 minutes.