TruVision IP PTZ Camera FW 5.1 Configuration Manual 23
2. Click the Enable Limit checkbox to enable the limit function.
3. Click the Set button and use the PTZ control panel to set the limits of the camera
movement. You can also call up defined presets and set them as the limits of the
camera.
Click Clear to delete the set limits.
4. Select the limit type.
Manual Stops: When manual limit stops are set, you can operate the PTZ control
panel manually only within the restricted surveillance area.
Scan Stops: When scan limit stops are set, the random scan, frame scan, auto
scan, tilt scan, panorama scan are performed only within the restricted surveillance
area.
Note: The option Manual Stops has priority over Scan Stops. If these two functions
are set at the same time, only Manual Stops is enabled.
The status of the camera movement is displayed under Type Status as Not Limited
or Limited. The limits changes are saved automatically
5. Click Save to save changes.
Scheduled tasks
You can configure the camera to perform a specific action automatically during a user-
defined time period.
To define a scheduled task:
1. From the menu toolbar, click Configuration > PTZ > Scheduled Tasks.
To Next Page
Loading...
