Interlogix zerowire ZW-6400 - Change Sensor Names

…C... 26 ZeroWire User Guide ..... I.....
To bypass a sensor using the ZeroWire panel:
1.
Select Bypass Menu.
2.
Enter PIN code with authority to
bypass.
3.
Select a zone to bypass.
4.
Toggle between un-bypassed to
bypassed state.
5.
Exits from Bypass Menu.
After bypassing your selected sensors, your security system must be armed
(turned on) in either the away or stay mode to secure the remaining sensors.
The status light will turn to yellow to indicate there are one or more bypassed
sensors. Touch the status key to check which sensors are bypassed.
2.14 Change Sensor Names
You can change the names of your sensors in the Settings Selector
menu.
From the UltraSync app press the
button then
You are on the
page.
Select the sensor you wish to name and type the new name in the box as
shown below. Remember to save your changes.
MENU
ENTER
ZONE NUMBER
0
ENTER
USER PIN
CODE