Intermec CV41

Appendix A — Specifications and Default Settings
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Manual 109
Enable Multicode Disable
Number of Bar Codes 2
Bar Code Separator <>
Complete Multicode UDM0
Incomplete Multicode UDM1
Code Mark *
Incomplete Transmission Disable
Incomplete Transmission Timeout 0
Bar Code 1-8 Symbology All
Bar Code 1-8 Length 0
Bar Code 1-8 Mask *
Enable Multicode Disable
Scanner Settings
Scanner Setting Default Value
Scanner Model SR Intermec Scanner
Trigger Mode Level
Aimer Mode Typical aimer
Hardware Trigger Enable
Trigger Timeout (sec) 2
Aiming Duration (msec) 500
Turn Off After Good Read Enabled/One-shot
Number of Good Read Beeps One
Energy Saver Mode Disable
Scanner Port Settings
Scanner Port Setting Default Value
Baud Rate 57600
Symbology Option Settings
Symbology Option Setting Default Value