Chapter 6 — Enable Screen Blanking
86 CV41 Vehicle Mount Computer (Windows Embedded Standard) User Manual
Sample Custom Serial Cable for Switch
Install Switch for Screen Blanking
This section explains how mount, connect, and enable the switch for
screen blanking.
1 Using your own mounting hardware, secure the switch sensor to
the vehicle.
2 Connect the serial cable to the switch. Make sure that Pin 7
connects to the switch connection and Pin 8 connects to the other
terminal.
3 Connect the serial cable to the COM 1 or COM 2 port on your
computer.
Enable Screen Blanking
After you have wired and mounted the motion switch sensor, you must
enable screen blanking in Intermec settings on the vehicle mount
computer.
1 In Intermec Settings, select Device Settings > Screen >
Screen Blanking on Motion.
Pin 8 Pin 7
To Next Page
Loading...
