Chapter 1 — Use the IP30
IP30 Handheld RFID Reader User Guide 7
Dispose of used batteries promptly. Keep away from children. Contact
your Intermec representative for replacement batteries.
Charge, Install, and Remove the Battery
To charge the IP30 battery you need a power supply, a country specific
power cord, and one of the following chargers or accessories:
• AC6 2-Bay Charger
• AC7 4-Bay Charger
• AC20 Quad Charger with IP30 Battery Pack Adapter
• AD20 Single Charger with IP30 Battery Pack Adapter
The IP30 does not ship with these accessories. For more information
on these accessories, contact your local Intermec sales representative.
A fully discharged battery charges to full capacity in approximately 4
hours. To charge the battery, insert the battery into the battery
charger.
After you charge the battery, you can use the battery with your IP30.
The battery used in this device may present a fire or chemical
burn hazard if it is mistreated. Do not disassemble it, heat it,
above 100 °C (212 °F), or incinerate it.
12
6
9
3
1
2
7
8
10
11
4
5
To Next Page
Loading...
