Chapter 1 — Use the IP30
8 IP30 Handheld RFID Reader User Guide
1 Insert the battery into the IP30.
2 Push the battery latch button and slide the battery in until the
battery is secure.
To remove the battery from the IP30, push the battery latch button on
the bottom of the IP30.
Attach or Remove the IP30
You can connect the IP30 using a Bluetooth connection, a USB
connection, or a USB connection connected to a common access card
reader. The IP30 can attach to the following mobile computers:
• CN3B, and CN3F Mobile Computers
• CN4 Series Mobile Computers
• CK3 Series Mobile Computers
• CK61 Series Mobile Computers
• 70 Series Mobile Computers
Note: Charging the IP30 battery does not charge the mobile computer
that it is connected to. For charging options, see your mobile
computer user manual.
To Next Page
Loading...
