Chapter 1 — Using the PB51 Mobile Label and Receipt Printer
PB51 Mobile Label and Receipt Printer User’s Guide 9
3 Insert the edge of the battery under the lip of the PB51 and then
push down until you hear the battery latch click.
Charging the Batteries
There are two ways to charge the PB51 battery:
tConnect AC power to the printer and charge the battery while it is
in the PB51.
tCharge the battery in the AC18 4-bay battery charger.
For information on charging your battery in the 4-b ay battery
charger, see the AC18 4-Bay Battery Charger Instructions
(P/N 943-128-xxx).
It takes approximately 6 hours to charge the battery while it is
installed in the PB51 printer. To charge the battery inside the PB51,
you need:
tan Intermec 12 VDC power supply (Model AE19).
tan AC power cord.
To charge the battery inside the PB51
1 Install the battery in the PB51. For help, see the previous section,
“Installing the Battery” on page 8 .
2 Connect the power supply to the DC power connector on the
printer.
3 Connect one end of the power cord to the power supply and then
plug the other end into an AC outlet.
To Next Page
Loading...
