Intermec PB51 - Con Guring Wireless Printing Using Fingerprint

Chapter 2 — Conguring the PB51
PB51 Mobile Label and Receipt Printer User’s Guide 33
where xxxx is the unique username and the unique password for
this protocol.
4 If you are using TTLS, you may need to send this co mmand to set
the TTLS outer name:
<STX><SI>ws,TTLS_USER, xxxx <ETX>
where xxxx is the outer name.
5 If you are using certicates for validation, here are some
commands you may need to use.
tSend the following commands to set a certicate and enable
validation:
<STX><SI>ws,CA_CERT, c:/testCA.pfx @ export <ETX>
<STX><SI>ws,VALIDATE,ON<ETX>
where c:/testCA.pfx is the location and name of the certicate
and export is the passphrase.
tSend the following commands to set a common name for
server 1 and server 2:
<STX><SI>ws, .SERVER_CN1, xxxxxxxxxx <ETX>
<STX><SI>ws, .SERVER_CN2, xxxxxxxxxx <ETX>
where xxxxxxxxxx can be a value from 0 to 64 characters.
tSend the following command to make sure your values match
those used by the access point:
<STX><SI>wt,[variable name]<ETX>
All variables are returned with the exception of EAP_PASS
which always returns “****” if congured and CA_CERT
which transmits the name of the last certicate au thority
successfully installed. An additional read-only var iable for the
supplicant state, called STATE, is also returned.
tYou may need to send the following command several times for
the wireless station to
connect:
<STX><SI>ws,ACTIVE,1<ETX>
Conguring Wireless Printing Using Fingerprint
Use the following procedures to congure your PB51 with
Fingerprint for wireless printing.