Intermec PB51 - Page 42

Chapter 2 — Conguring the PB51
32 PB51 Mobile Label and Receipt Printer User’s Guide
To congure the printer to use WPA-PSK or WPA2-PSK mode
1 Send the following commands to login as an admin an d set the
SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID, xxxxx <ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following commands to turn on WPA o r WPA2
authentication. Send the WPA-PSK or WPA2-PSK comman d to set
a pre-shared key:
<STX><SI>ws,WPA,ON<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, xxxxxxxxxx <ETX>
where xxxxxxxxxx is a value between 8 and 64 characters.
3 Send the following command to activate the settings:
<STX><SI>ws,ACTIVE,1<ETX>
To congure the PB51 to use WPA or WPA2 Enterprise mode
1 Send the following commands to login as an admin an d set the
SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID, xxxxx <ETX>
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following commands to enable WPA-802.1x or
WPA2-802.1x authentication. You should also send th e WPA_PSK
command that does not contain a value:
<STX><SI>ws,WPA,ON<ETX>
<STX><SI>ws,WPA2,ON<ETX>
<STX><SI>ws,WPA_PSK, <ETX>
3 Send these commands to congure the EAP_TYPE:
<STX><SI>ws,EAP_TYPE, xxxx <ETX>
where xxxx can be OFF, LEAP, PEAP, or TTLS.
<STX><SI>ws,.EAP_USER, xxxx <ETX>
<STX><SI>ws,.EAP_PASS, xxxx <ETX>
Note: The default password for logging in as an admin is “pass.” If
you have changed the password, you will need to use your password
instead of “pass.”