Intermec PB51

Chapter 2 — Conguring the PB51
18 PB51 Mobile Label and Receipt Printer User’s Guide
Conguring the PB51
You can change the conguration settings of the PB 50 printer directly
from the display, by sending commands from your PC, by using the
web pages, or remotely from the SmartSystems console.
For more information on the IPL and Fingerprint men u systems,
see
“IPL and Fingerprint Setup Menus” on page 57 .
Understanding the Display Modes
The PB51 has six display modes to help you eectiv ely interact with
the printer: Ready, Information, Paused, Setup, Err or, and Test. Use
the following sections to understand the dierent printer modes.
Understanding Ready Mode
The printer is in Ready mode when the printer is on and ready to
print. The main screen displays the power status, t he radio status, and
the printer language and version.
The PB51 in Ready Mode
Understanding Information Mode
When the printer is in Information mode, it display s a subset of
network information about the printer. If the printer experienced an
error, the error message displays rst followed by the printer
information. Each message displays on the screen for ve seconds.
After ve seconds on the last information screen, the printer exits
Information mode.
The PB51 in Information Mode
SETUP:
SER-COM
IPL 11.2.0
SETUP:
SER-COM
I/O serial 5
8N1 9600
X