Chapter 2 — Conguring the PB51
36 PB51 Mobile Label and Receipt Printer User’s Guide
where xxxxxxxxxx can be a value from 0 to 64 characters.
tSend the following command to make sure your values match
those used by the access point:
setup write "8021x","uart1:"
tYou may need to send the following command several times for
the wireless station to connect:
setup "wlan","ACTIVE","1"<ETX>
Setting Up USB Communications
To set up USB communications with your PC, you will need:
tUSB cable
tIntermec InterDriver® software
You can download the InterDriver software from the Intermec web
site at
www.intermec.com .
Setting Up Serial Communications
Use a serial cable (P/N 075497-001) to connect the PB51 to a PC or a
mobile computer. For the mobile computer, you may need to
purchase a serial adapter. For more information, co ntact your local
Intermec sales representative.
Before you can establish a serial connection, you need to make sure
that the settings on the PC or mobile computer matc h those of the
PB51.
Serial Port Settings on the PB51
To Next Page
Loading...
