Intermec PB51 - Page 45

Chapter 2 — Conguring the PB51
PB51 Mobile Label and Receipt Printer User’s Guide 35
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID"," xxxxx "
where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send one of the following WPA/WPA2 ON commands to s et up
WPA-802.1x or WPA2-802.1x authentication. You shoul d also
send the WPA_PSK command that does not contain a value:
setup "wlan","WPA","ON"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK",""
setup write "wlan","uart1:"
tTo view the 802.1x values, send this command:
setup write "8021x","uart1:"
3 Send these commands to congure the EAP_TYPE:
setup "8021x","EAP_TYPE"," xxxx "
where xxxx can be OFF, LEAP, PEAP, or TTLS.
setup "8021x",".EAP_USER"," xxxx "
setup "8021x","EAP_PASS"," xxxx "
where xxxx is the unique username and the unique password for
this protocol.
4 If you are using TTLS, you may need to send this co mmand to set
the TTLS outer name:
setup "8021x","TTLS_USER"," xxxx "
where xxxx is the outer name.
5 If you are using certicates for validation, here are some
commands you may need to use.
tSend the following commands to set a certicate and enable
validation:
setup "8021x","CA_CERT"," c:/test.pfx @ export "
setup "8021x","VALIDATE","ON"
where c:/test.pfx is the location and name of the certicate and
export is the passphrase.
tSend the following commands to set a common name for
server 1 and server 2:
setup "8021x",".SERVER_CN1"," xxxxxxxxxx"
setup "8021x",".SERVER_CN2"," xxxxxxxxxx"