Intermec PB51 - Con Guring Wireless Printing Using IPL

Chapter 2 — Conguring the PB51
PB51 Mobile Label and Receipt Printer User’s Guide 31
Use the following sections to set most of your wireless
communication settings. For help with additional co mmands and
information, see either the Fingerprint Command Reference Manual (P/N
937-005-xxx) or the IPL Command Reference Manual (P/N 937-007-xxx).
You can download both documents from the Intermec web site at
www.intermec.com .
Conguring Wireless Printing Using IPL
Use the following procedures to congure your PB51 with IPL for
wireless printing.
To congure the printer to use WEP authentication
1 Send the following commands to login as an admin an d set the
SSID:
<STX><ESC>.x,su -p pass admin<ETX>
<STX><SI>ws,SSID, xxxxx <ETX>
where xxxxx can be from 0 to 32 ASCII characters, not includin g
the double quote.
2 Send the following commands to congure the WEP ke ys. The
following example sets WEP key 1 to 1234 and enables WEP key 1.
<STX><SI>ws,WEP1, 0x0001020304<ETX>
<STX><SI>ws,.WEP_KEY,1<ETX>
3 Send the following command to activate the settings.
<STX><SI>ws,ACTIVE,1<ETX>
Weak signal
Poor signal
No signal
Understanding the 802.11 Radio Icons (continued)
Icon Description
Note: The default password for logging in as an admin is “pass.” If
you have changed the password, you will need to use your
password instead of “pass.”