Intermec PB51 - Page 48

Chapter 2 — Conguring the PB51
38 PB51 Mobile Label and Receipt Printer User’s Guide
You have options for upgrading the rmware based on whether your
PB51 has a Bluetooth radio, an 802.11 b/g radio, or no radio. Use one
of the following procedures to upgrade your printer rmware. Your
printer should reboot after you nish upgrading th e rmware. If it
does not reboot, you will need to cold boot the printer. For help, see
“Cold Booting the PB51” on page 48 .
To upgrade your printer using PrintSet
1 Download the latest version of PrintSet from the In termec web
site at
www.intermec.com .
2 Select File > Add Printer to start the Add Printer Wizard which
guides you through the process of adding your printer.
3 Select your printer under My Printers and then go t o Printer >
Firmware Wizard .
The Firmware Wizard guides you through the necessar y steps to
update your rmware.
To upgrade your printer using an 802.11 network connection
1 Browse to the home page of the printer. For help, see
“Changing
Conguration Settings From the Printer Home Page
” on
page 26
.
2 From the home page, click Maintenance .
3 From the Firmware upgrade page, browse to the upgrade rmware
le.
4 Click Upgrade .
To upgrade your printer using a serial connection
1 Make sure you have established serial communications between
your PC and the PB51. For help, see
“Setting Up Serial
Communications” on page 36
.
2 Use Fingerprint, IPL, or ESC/P commands to send the upgrade le
to the printer.
For help with Fingerprint, IPL, or ESC/P commands a nd information,
see the Fingerprint Command Reference Manual, the IPL Command
Reference Manual, or the ESC/P Programmer’s Reference Manual. You can
download all of the documents from the Intermec web site at
www.intermec.com .