Intermec PB51 - Page 53

Chapter 3 — Troubleshooting and Maintaining the PB51
PB51 Mobile Label and Receipt Printer User’s Guide 43
Possible PB51 Error Icons and Messages
Error Icon Error Message
Description
Pause The print job is paused.
Paper out (IPL)
Out of Paper
(Fingerprint)
The printer is out of paper. Load a new roll of
media. For help, see
“Loading Media” on
page 11
.
Testfeed not
done
The printer did not perform a testfeed before
it printed out test labels. It is important to
perform a testfeed because it calibrates the
sensor.
To perform a testfeed:
tIn Fingerprint and ESC/P, press the Feed
button for more than 2 seconds.
tIn IPL, open and close the media door and
then press the Feed button.
‘
Printhead hot The printhead is overheated and needs to
cool down. In IPL, wait for printing to resume
automatically. In Fingerprint and ESC/P,
your print job is lost.
Upgrading The printer is loading new rmware.
LSS too high,
LSS too low
These errors can occur when you run a test
feed without any media installed, or if you
have incorrect media settings.
Load the printer with media (see
“Loading
Media” on page 11
), run Test mode (see
“Using Test Mode” on page 21 ), and select
the appropriate media type.
IP conguration
error
The printer is trying to acquire an IP address
from the network. Wait for the printer to
complete the task before taking any acti
on.
IP link error No network connection.