Intermec PR3

Chapter 1 — About the Printers
PR2 and PR3 Mobile Receipt Printer User Manual 5
Intermec
Ready-to-Work™
indicator
Indicates if the printer is ready to print:
• Steady blue: Printer is ready
• Blinking blue: Printer is on but not
ready (connected to a power source
but no battery installed, or there is a
critical error)
• Off: Printer is not ready (Off or in
Deep Sleep mode)
Magnetic Stripe
Reader
Indicates if a card was successfully read:
• Blinks green three times: card
successfully read
• Blinks red one time: card not
successfully read
Connectivity Indicates data transfer:
• Blinking white: Sending or receiving
data
• Off: Not sending or receiving data
Critical Error Indicates an error state or upgrade
process:
• Steady red: Out of media, next label
not found, test feed not done, test
feed failed, door open, printhead
not detected, printhead too hot, or
motor too hot
• Off: Printer is operating normally
Status LEDs and Icons (Continued)
LED or Icon Name Status
Note: While you use the printer, the LEDs and icons also turn on, turn
off, or blink in different combinations to indicate additional status
information, such as Power Mode or firmware upgrade status.