Intermec PR3

Chapter 3 — Troubleshoot and Maintain the Printer
32 PR2 and PR3 Mobile Receipt Printer User Manual
Print a Test Label
1 Turn off the printer by pressing and holding the Power button for
5 seconds. After 2 seconds, the three LEDs blink once, and after 5
seconds the three LEDs blink three times. The printer turns off.
2 Press and hold the Print button, and then press and hold the
Power button. The blue Intermec Ready-to-Work™ indicator
starts to blink.
3 Continue to hold the buttons until the Ready-to-Work indicator
stays on solid (about 15 seconds). The printer prints a test label.
Bluetooth
Configuration
Device Address
Device Name
Reserve
Authentication
Encryption
Connectable
Discoverable
Secure Simple Pairing
MFi (Made For iOS) logo
Battery Serial Number
Charge Cycles
Battery Voltage
Magnetic Stripe
Reader
Installed
Test Label Contents (Continued)
Category Contents