EasyManua.ls Logo

Intex 128352NP - User Manual

Intex 128352NP
54 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Zusammengeführte PDF Datei. Die Originale sind im folgenden Verzeichnis verlinkt. / Merged PDF File. Original files are linked in the following list. / Sloučený soubor PDF.
Originály jsou propojeny v následujícím adresáři. / Egyesített PDF fájl. Az eredetiek a következő könyvtárban találhatók. / Zlúčený súbor PDF. Originály sú prepojené v
nasledujúcom adresári. / Združena datoteka PDF. Izvirniki so povezani v naslednjem imeniku. / Spojena PDF datoteka. Izvornici su povezani u sljedećem imeniku.
128352NP - Frame Pool Set Ultra Quadra 549 x 274 x
132 cm
Above Ground Pool 2
165IO 17
193IO 29
Overview Pool Size vs Pump Running Time 51
Air Valve For Water Revitalization Set 53
Mounting 54

Table of Contents

Questions and Answers

  • D
    Destiny JamesAug 27, 2025
    How to fix Intex Water Pump filter motor that fails to start?
    • M
      Michael BrownAug 27, 2025
      If the Intex Water Pump filter motor won't start, ensure the line cord is plugged into a 3-wire outlet protected by a Class A Ground Fault Circuit Interrupter, or RCD. Also, reset the GFCI/RCD circuit breaker; if it repeatedly trips, your electrical system may have a defect, so turn off the breaker and consult an electrician. Finally, the motor may be too hot; let it cool down before restarting.
  • M
    Michelle SullivanAug 25, 2025
    Why my Intex 128352NP Water Pump doesn't work?
    • L
      laura80Aug 26, 2025
      If your Intex water pump isn't working, start by checking the water level; ensure it's at the correct level. Next, inspect the strainer screens at the pool inlet for clogs and clean them if necessary. Also, check the intake hose for air leaks by tightening the hose nuts and inspecting the hose for damage. If these steps don't resolve the issue, the motor may be faulty or the impeller jammed.
  • H
    Hunter GarrisonAug 23, 2025
    What to do if Intex 128352NP Water Pump doesn't pump water or flow is very slow?
    • B
      Brian RobinsonAug 25, 2025
      If your Intex Water Pump filter isn’t pumping water or the flow is very slow, there might be trapped air in the system – release the air according to the operating instructions section. Check for clogs in the inlet or discharge and clear any obstructions. Also, inspect the intake line for air leaks, tightening hose nuts and checking for damage, and ensure the pool water level is adequate. Backwash the filter if the pool is excessively dirty. If the sand media is clogged with dirt, remove about 1” of sand if necessary. Make sure the nozzle is at the upper position of the pool inlet, and the strainer at the lower position of the pool outlet. Remove any pool vacuuming device attached to the system line, if there is crusting or caking on the filtering sand surface.

Intex 128352NP Specifications

General IconGeneral
BrandIntex
Model128352NP
CategoryWater Pump
LanguageEnglish

Related product manuals