Intex 28214 - Fitting the Skimmer

Assembly
19
− In order to prevent the pump from falling over accidentally, fit it to a cement or
wooden base (see Fig. D).
The subsurface must have a load-bearing capacity of more than 18 kg.
The pump is supplied with the air release valve
18
open. The air release valve must
not be screwed shut until you reach step 8. Failure to follow these instructions can
cause air to accumulate inside the pump housing, cause the motor to run dry, become
noisy and break down.
1. Ensure that there is a water connection for filling the pool and the chemicals are
available.
2. First assemble the pool.
3. Insert the nozzle connection (consisting of the inlet connection
26
and pool inlet
nozzle
27
) from inside into the left hose connection
15
(see Fig. C).
4. Attach the air adapter to the pool inlet
24
on the left hose connection from the
outside with a hose clip
22
.
5. Screw the air jet valve
25
tight to the air adapter of the pool inlet.
6. Insert the filter unit (consisting of the filter connection
29
and filter sieve
28
)
from the inside into the right hose connection
16
.
The right hose connection is marked with a “+” on the pool liner.
7. Insert the two pump hoses
23
into the pump hose connections.
8. Attach the pump hoses with the hose clips.
9. Attach the top pump hose to the right hose connection from the outside with a
hose clip.
10. Attach the bottom hose to the air adapter on the pool inlet with a hose clip.
11. Make sure that all the hose clips are tightened firmly.
Ensure that the air jet valve is screwed tight on the pool inlet air adapter and is
pointing upwards.
12. Unscrew the housing collar
19
anticlockwise and remove it from the pump
housing.
13. Remove the housing cover
20
.
14. Make sure that there is a filter cartridge
21
in the pump housing.
15. Plug the mains cable on the pump into the transformer
30
and tighten the union
nut.
Fitting the skimmer
1. Connect the skimmer hose
33
to the skimmer
35
(see Fig. G, step 1).
2. Connect the stabiliser
32
to the skimmer holder
31
(see Fig. G, step 2).
3. Then plug the stabiliser into the skimmer and fix it in place with the fixing screw
(see Fig. G, step 3).