Assembly
21
3. Fill the pool with water until it reaches just below the inner seam.
Emptying the pool
NOTICE!
Risk of damage!
If the water level is too high, it can damage the pool.
− If the water level is higher than the maximum mark, drain
some water off as quickly as possible to avoid damage from
overfilling the pool. This can happen very quickly in heavy
rain.
When emptying the pool, the water must be drained in accordance with local regula-
tions, e.g. into the sewage system.
1. Ensure that the outlet valve
14
is in the correct position.
2. Unscrew the drain valve cover
6
from the drain valve.
3. Screw the drain adapter
7
onto the drain valve.
4. Attach a garden hose to the drain adapter.
5. Lay the garden hose so that the water can flow into a drain (e.g. into the sewage
system).
6. Open the drain plug on the inside of the pool.
The water will start to flow out through the garden hose immediately.
7. When the water stops running out on its own, lift the pool on the opposite side to
the drain valve.
This will empty the remaining water out of the pool.
8. When the pool is completely empty, remove the garden hose from the drain
adapter.
9. Unscrew the drain adapter from the drain valve.
10. Seal the outlet valve on both sides with the drain plug and drain valve cover.
To Next Page
Loading...
