(133IO) SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 04/10/2022
133
A
SAVE THESE INSTRUCTIONS
English
Page 11
OPERATION INSTRUCTIONS
1. Turn on the filter pump.
2.
Start up the unit:
Plug the power cord into the electrical outlet and test the RCD (circuit
breaker). Press
button. Flashing code “00” appears on the electronic
control station’s LED, indicating that the unit is ready to be programmed.
3. Set operating hours for Saltwater system:
With code “00” flashing, press
button to set
the desired operating hours. See the “Operating
Time Table” for the required operating hours
related to each pool size. Pressing
will
increase the time from 01 to 12 hours maximum.
If you have selected too many hours keep
pressing to repeat the cycle. The built-in
timer will now activate your Saltwater System, at
the same time each day, for the number of hours you have set.
NOTE:
The Saltwater System will not operate if the filter pump is not operating. Make sure
to program your filter pump (or start it manually) for operation beginning 5 minutes before
the Saltwater System and finishing 15 minutes after the Saltwater System.
4. Lock keypad controls:
With the desired hour value showing, press
button. A green
“WORKING” indicator on the control panel will light up within a few
seconds to indicate that the saltwater system has started sodium
hypochlorite production, the LED will display the remaining chlorinator
hours until it’s finished. Locking the control buttons into this setting
prevents unauthorized changing of the operating cycle.
NOTE:
If you forget to lock the keypad controls, the system will
automatically lock it and start working 10 seconds later.
5.
Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Press
button and the current
programmed time will flash. Repeat steps 3 to 4.
6. Stand-by/power saving mode:
• When the cycle ends, the green “SLEEP” indicator on the control
panel lights up and the LED display flashes “93”. The system is now
in Stand-By mode. After a while, it shuts down and sets itself in a
Power Saving mode. The system will automatically turn itself back on
in 24 hours, starting its daily cycle of chlorine production.
• The “SLEEP” indicator stays on, while the system is in the Power
Saving mode. The LED display however, goes blank after 5 minutes.
Press any button (
or ) to view the last LED code.
(1 to 12 hours max per cycle)
To Next Page
Loading...
Need help?
General
