Invasix InMode - Pre-Treatment Recommendations; Tip Cleaning Instructions Prior to Use; Treatment Recommendations

InMode Without Vasculaze Operator Manual
Section 6 – Diolaze Treatment
Information

40 of 96
 Determine why the patient is seeking treatment and what his/her expectations
are.
 Inform the patient about treatment arrangement, typical treatment results and
possible side effects and discomfort.
 Instruct the patient about the safety warnings.
 Advise the patient to avoid skin irritation or skin tanning. Sunscreen is advisable
during outdoor activity at daylight hours.
 The patient should discontinue any irritant topical agents for 2-3 days prior the
treatment.
 Stop anticoagulants 7-10 days prior to treatment, if medically permitted.
 Photograph the patient.
 Mark the treatment area with a white marker.
 Clean the Handpieces parts that come in contact with the skin with 70% alcohol.
Treatment area should be shaved prior the treatment. Hairs may absorb
light and leave burn mark on the skin.
 Tip Cleaning Instructions Prior to Use
Clean the Handpiece output window with 70% alcohol absorbed pad for at least
30sec and dry completely.
 Treatment Recommendations
 Follow Device Start-Up Procedure from System Operation section.
 Shave the treatment area and ensure that skin is clean.
 Apply thin layer of water based gel to the treated area.
Prior to using water-based gel, ensure that the container of ultrasound gel
has not passed the expiration date.
 Make a test-spot with Normal/Weak Cooling to see epidermal end-points of
perifollicular erythema/edema. Change to Strong Cooling while treating for
better comfort and safety. Perform the test spot in the area to be treated in a
non-conspicuous site and wait according to the Table below to check the
response.