Invitrogen Qubit 4 - Page 14

12 Qubit
™
4 Fluorometer User Guide
Adjust the sleep
mode
The Qubit
™
4 Fluorometer has a sleep mode (i.e., automatic standby) that is
triggered by inactivity. The system default is 10 minutes of inactivity before the
instrument goes into sleep mode. To adjust this time:
1. On the Instrument settings screen (page 11), press Sleep mode to display the
Sleep mode screen.

2. Enter the time in minutes allowed before the instrument goes into sleep mode
by pressing the minutes field, then using the number pad to select a value.
The
software requires a minimum of 1 minute and a maximum of 60 minutes.
3. Press Done to save the changes and return to the Instrument settings screen.
Press Cancel or Back ( ) to return to the Instrument settings screen without
saving the changes.
Adjust screen
brightness
1. On the Instrument settings screen (page 11), press Brightness to display the
Brightness screen.

2. Move the slider button up or down to adjust the brightness of the display.
3. Press Done to save the changes and return to the Instrument settings screen.
Press Cancel or Back ( ) to return to the Instrument settings screen without
saving the changes.