Need help?Do you have a question about the INVT GD100 and is the answer not in the manual?
General| Control Mode | Torque Control |
|---|---|
| Protection Functions | Overcurrent, Overvoltage, Undervoltage, Overload, Overtemperature, Short Circuit |
| Operating Temperature | -10°C to +50°C |
| Storage Temperature | -20°C to +60°C |
| Humidity | 5% to 95% (non-condensing) |
| Altitude | 0~1000m (Derating above 1000m) |
Explains LEDs for running status, direction, operation mode, and fault conditions.
Covers unit indicators, the 5-digit LED display zone, and the analog potentiometer.
Details the function of programming, navigation, run, stop/reset, and shift keys.
Covers fundamental parameters like run command, frequency limits, and acceleration/deceleration times.
Details parameters for stop mode, operation protection, and restart behavior after power loss.
Lists settings for motor type, rated power, frequency, speed, voltage, and current.
Explains terminal function selections (S1-S5) and HDI terminal function.
Details special parameters for PV inverters, including selection, voltage reference, and frequency limits.
Configuration for current detection of underload operation for PV inverters.
Covers factory default reset and master reset procedures for the drive.
To Next Page