INVT iMars - Page 49

iMars grid-tied solar inverters Display panel
47
Control Menu
On / Off
Clear
Restart
Factory
On / Off Ctrl
ON
OFF
Clear all Record : Sure ？
Press ENT to execute .
Press ESC to cancel .
Restart
Press ENT to execute .
Press ESC to cancel .
Restore to Factory
Press ENT to execute .
Press ESC to cancel .
System Information
Part No .
Serial No .
Soft Ver
Cert . Area
Part No .
iMars BG 5 KTL
Serial No .
BGTL 100 - 00
System Ver
Version 1 : V1. 05
Version 2 : V1. 05
MCU Version : V 1. 05
Certificate Area
AS 4777
Run Param
Run Param
UV Volt .
UV time .
OV Volt
OV time
UF Freq
UF time
ACUV Time
200ms
Table 6-4 Parameters setting
Setting item
LCD display
Instruction
RS485
Address
RS 4 85 A d d r e ss
00 1
1
Enter into the interface and edit the data
through “ ” or “ ”. And then press
“ENT” again to the next bit. After editing
the three bits, press “ENT” to save the
edition and press “ESC” to exit.
User
password
Us e r P a s s w o rd
00 0 0
0
Enter into the interface and edit the data
through “ ” or “ ”. And then press
“ENT” again to the next bit. After editing
the four bits, press “ENT” to save the
edition and press “ESC” to exit.
The default password is “0000”; the
user can enter into the setting interface
without password. If the password is not
“0000”, the user can enter into the
setting interface with password.