Single Phase Hybrid Inverter Troubleshooting
65
Remote shutdown
instruction
Check whether any one is trying to shut
down the inverter remotely.
Please turn off the inverter and open the
input and output switches, and turn on the
inverter again 5 minutes later. If the fault
still exists, contact your dealer.
Power-on
self-test error of
AFCI
Power-on self-test
error of PV string 1
Please turn off the inverter and open the
input and output switches, and turn on the
inverter again 5 minutes later. If the fault
still exists, contact your dealer.
Power-on self-test
error of PV string 2
Please turn off the inverter and open the
input and output switches, and turn on the
inverter again 5 minutes later. If the fault
still exists, contact your dealer.
Check whether the AC wires are
connected properly and reliably to the
inverter.
Power-on
self-test error of
leakage current
Leakage current
sensor failure
Please turn off the inverter and open the
input and output switches, and turn on the
inverter again 5 minutes later. If the fault
still exists, contact your dealer.
Please turn off the inverter and open the
input and output switches, and turn on the
inverter again 5 minutes later. If the fault
still exists, contact your dealer.
Please turn off the inverter and open the
input and output switches, and turn on the
inverter again 5 minutes later. If the fault
still exists, contact your dealer.
Check whether the correct wire is
connected properly to the EPS port.
Table 10-2 Warning Codes of Inverter
Please turn off the inverter and open the input
and output switches, and turn on the inverter
again 5 minutes later. If the fault still exists,