12
Ioline 300/350HF System Quick Start Guide
4. Peel the back-
ing paper off
of one side of
the Adhesive
sheet. With the
exposed side
facing the Tray,
align the corners
of the sheet with
the engraved
“L” shaped
marks in the
Tray (Figure 9).
5. Smooth the
adhesive sheet
down until all bubbles are removed. Leave the paper cover on
the top of the adhesive sheet until ready to apply material for
cutting.
Figure 9. Align the adhesive sheet with the L-shaped
Tray alignment marks.
Figure 8. Adhesive Sheet and backing material guidelines.
High Tack
(HT)
Scrim felt, leather, etching and stencil
board. Order 107076
Medidum Tack
(MT)
A general purpose sheet, use with most
twills. Order 107295
Low Tack
(LT)
Heatseal-backed or thin and fragile
materials. Order 107093
Ultra Low Tack
(ULT)
Paper or paper-backed materials. Order
108300
2-sided Backing
(2S)
Adds adhesive to non-backed materials.
Order 107089
1-sided Backing
(1S)
Stabilizes thin materials. Order 106277
To Next Page
Loading...
