Tiger PC software
2. Click on ‘Instrument(s)’. If your TIGER has previously been connected to your PC your instruments
IRN (Internal Reference Number) will appear.
Note: If, while using this software your TIGER should inadvertently be turned off or disconnected from
your computer, click on ‘Instrument(s) again and proceed as below:
3. Switch TIGER on and when fully booted up connect to a USB socket on your PC using the USB cable
supplied. If the ‘Found New Hardware’ screen appears, follow the prompts to install your instrument
on your PC.
4. Click on ‘Read’. Your instrument number will appear under ‘instrument(s)’ (if it was not there already)
and the Instrument Summary page will appear.
To Next Page
Loading...
