Ion Technologies IT- DS05-S - 3.2 Checking Module Torque - First time operation

IONTECH
®
IT-DS EDI Modules
3.2
Checking Module Torque - First time operation
If the nuts on the threaded tie bars have loosened during shipment, the
pressure from the incoming water can cause permanent damage.
Therefore the bolt torque must be checked and the module tightened as
required before flowing water into the module.
Always drain water from the IT-DS module before tightening the endplate tie
bar nuts. This relieves pressure in the module. Failure to do so can
result in irreversible damage.
Do not open the IT-DS Module. Opening the module will void the warranty
and do irreversible damage.
Before starting the IT-DS Module for the first time, check the tightness of the Module end plate tie-
bar nuts. Referring to Figure 3-1 and Table 3-1, tighten as required. Not all modules will need
tightening.
13 IT-DS MAN Rev 0