5.5 Remote Controls
The included 12-button remote control is preprogrammed to the Alpha MUTT
®
and should never lose its
programming. If you suspect a remote has lost its programming, contact Technical Support at 888-786-
7899 or email tech247@ipatools.com.
How to Program the 12-Button Remote
1. Press and hold the Clearance button while turning the
Alpha MUTT
®
’s main power ON.
2. Continue to hold the button for two seconds and then release.
3. The remote control is now programmed.
How to Use the 12-Button Remote
1. Circuit Selection
Pressing the buttons will select the corresponding circuit on
the Alpha MUTT
®
. (Pressing and holding the ABS/AUX or
Brake Light buttons will latch both circuits on.)
WARNING: Inclement weather, nearby power transformers and closely parked trailers may reduce
the remote signal.
To Next Page
Loading...
