iPA ALPHA MUTT - Page 5

Operating the Alpha MUTT
®
App
7.1 Application Setup …………………………………………………………............…….
Accounts
Company Information
Testing Defaults
7.2 Menu Bar Screens …………………………………………………………............……
7.3 Diagnostic Controls …………………………………………………………...........…..
Electrical/Lighting Testing
8.1 Pretest Checklist …………………………………………………………......................
Tester Placement
Maintain Connectors
Cable Testing Procedure
8.2 Selecting a Circuit ……………………………………………………............………….
Auto-Cycle Mode
8.3 Ground Integrity Test …………………………………….............……………………..
Chassis and Pin Grounds
Establishing a Chassis Ground
8.4 Fault Indication …………………………………………………………………..............
Open Circuit
Crossed Circuits
Short/Overloaded Circuit
8.5 Activating Hazard Lights ………………………………………………………..............
8.6 All Circuits On (Override) Mode ………………………………………………..............
Air Brake Testing
9.1 Testing Set-Up …………………………………………………………….....................
9.2 Actuating Air Brakes ……......................………………………………........................
9.3 Leak Down Testing ………………………………………………………......................
Manual Leak Down Test
Automatic Leak Down Test
Changing Automatic Leak Down Test Parameters
ABS Diagnostics
10.1 Accessing ABS Codes ………………………………………………...........................
ABS Explained
10.2 Manual Controls ………………………………………………………..........................
Accessing Active Faults
Accessing Stored Faults
Clear All Codes
10.3 Tablet Controls ………………………………………………………............................
10.4 Failure Mode Identier (FMI) Assignments ……………………….............................
10.5 SAE J1587 Mid 137 Sid List …………………………………………..........................
Inspections and Reporting
11.1 Electrical Inspections …………………………………………………..........................
Pass Result
Fail Result
11.2 DOT/PM Inspections …………………………………………………..........................
Truck Inspections Controls
Trailer Inspections Controls
11.3 Saved Reports ……………………………………………………….............................
11.4 Inspection Creator Tab ………………………………………………...........................
11.5 Sample Reports ………………………………………………………...........................
Updating Firmware
12.1 Updating Front Face Panel ……………………............................…………………...
12.2 Updating ABS Module ………………………………………….............................…..
Part 7:
Part 8:
Part 9:
Part 10:
Part 11:
Part 12:
7-1
7-2
7-3
8-1
8-2
8-4
8-5
8-6
8-7
9-1
9-2
9-4
10-1
10-2
10-4
10-5
10-6
11-1
11-4
11-7
11-8
11-9
12-1
12-1