PART 13: MAINTENANCE
13.1 Maintenance and Storage
• Switch power to OFF, remove all power cables and disconnect battery before storing and
cleaning.
• Wipe surfaces down with a well-wrung, soft, damp cloth.
• Diluted dishwashing liquid or similar substance can be used in the dampened cloth if
necessary.
• Frequently clean and resize the 7-way pin connectors and add dielectric grease to the 7-way
pin connector outlet. This will ensure a proper connection when using your Alpha MUTT
®
.
• Do not allow water to enter the control panel.
• Store in a cool, dry area when not in use and cover your Alpha MUTT
®
to prevent dust from
accumulating.
• Do not store in direct sunlight.
• Do not store near magnetic field or damage to the microprocessor may occur.
• Make sure your air supply is run through a water separator and is filtered before attaching air
supply to the tester.
To Next Page
Loading...
