IPC CT80 - Practical Guide for the Operator; Preparing the machine for work

GB
PRACTICAL GUIDE FOR THE OPERATOR
! WARNING!
Before starting work, wear overalls, ear protectors, non-slip and waterproof shoes, mask to
protect the respiratory tract, gloves and all other personal protection devices necessitated
by the work environment.
! WARNING!
Do not leave the machine unattended or parked with the key in the switch and the parking
brake disengaged.
! IMPORTANT!
If you are using the machine for the rst time, we recommend trying it out on a large obsta-
cle-free surface rst to acquire the necessary familiarity.
! WARNING!
To avoid damaging the surface of the oor you are cleaning, avoid rotating the brushes with
the machine stationary.
! IMPORTANT!
The machine is tted with a driver detection device. It is only possible to start the machine
while seated correctly in the driving seat. The device halts the machine if you get up from
the seat.
! WARNING!
Always dilute the detergent according to the manufacturer’s instructions. Do not use so-
dium hypochlorite (bleach) or other oxidants, particularly in strong concentrations. Do not
use solvents or hydrocarbons. The water and detergent temperature must not exceed the
maximum indicated in the “Technical specications”. They must be free of sand and/or other
impurities.
The machine has been designed for use with low-foam biodegradable detergents made spe-
cically for scrubber driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the
Manufacturer:
Use products suitable for the oor and dirt to be removed only.
Follow the safety regulations on use of detergents given in the section “Safety regulations”.
Preparing the machine for work
Proceed as follows before starting work.
► Check that the display shows the batteries to be fully charged. Recharge if necessary. See
the “Battery maintenance and charging” section.
► Make sure that the dirty water tank is empty. Empty it if necessary, see “Emptying the dirty
water tank”.
► Make sure that the solution tank is full. Fill it if necessary, see “Filling the water/detergent
tank”. If the machine is not tted with the “Chem-Dose” accessory, add detergent to the
tank in the required percentage, using the measuring cap.
20