IPC CT80 - Replacing the squeegee blades

GB
“ONBOARD” battery charger:
► Lift the dirty water tank
► Unplug the battery charger.
► Plug the cable into the power socket (g. 25).
► Start the recharge cycle.
► The display will show when the recharge cycle ends, see “Display alarms”
► At end of the recharge cycle, unplug the cable from the power socket.
Replacing the squeegee blades
► Switch the machine on, lower the squeegee by pressing the suction motor button.
► Remove the suction hose from the squeegee (g. 26).
► Unscrew the fastening knobs.
► Remove the squeegee from the slots on the support.
26
25
33