GB
Fuses: replacing
! DANGER!
This operation must be performed with the machine switched o and the key removed.
! WARNING!
Never use a fuse with a higher amperage than specied.
! DANGER!
Do not rest the electronic board panel on the batteries, as a short-circuit may cause the bat-
teries to explode.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be identied
and repaired. Have the machine checked by qualied personnel.
Lift the dirty water tank, disconnect the battery wiring connector from the electrical system (g. 20,
ref. 1-2-3), lift the electronic board panel, secure it to the corner of the tank, as shown in the gure
(g. 21), then check the fuses.
20 21
30
To Next Page
Loading...
