iPECS LIP-8012D - 2.2 Using the Speakerphone

LIP-8012D & LIP-8024D User Guide
11
2.1.5 Attendant menu (iPECS-LIK)
The Attendant menu is only available on the System
Attendant phone.
2.2 Using the Speakerphone
Activate the iPECS Speakerphone at any time (except
for Paging) in place of lifting the handset to receive or
place calls.
Additionally, you may switch between the handset and
Speakerphone during a call. By keeping the handset
Off-hook, the Group Listen feature is activated, which
provides incoming audio over the speaker with outgoing
audio from the handset. This permits a local ‘group’ to
listen to both sides of the conversation without
interfering with the conversation.
While in a conversation using the Speakerphone, Mute
the microphone using the MUTE button. When Mute is
active, the MUTE button LED will be illuminated. To turn
off Mute, press the MUTE button again..
To access the Attendant menu:
 Press MENU button and 5 (Attendant); the following will
display:
1. DATE/TIME SET
2. SET ICM ONLY MODE
3. RESTORE COS
BACK OK
4. MONITOR CONF ROOM
5. DELETE CONF ROOM
BACK OK
Date/Time Set—Enter mm/dd/yy, and press OK Soft
button; enter hh/mm, and press OK Soft button.
Set ICM Only Mode—Dial the Station Range for ICM
only calls (ex., 103-108=103108), and press the OK
Soft button.
Restore COS—Dial the Station Range for COS
restoring (ex., 103-108=103108), and press the OK
Soft button.
Monitor Conference Room—Enter the Conference
Room number to view the number of attendees in the
Conference Room.
Delete Conference Room—Enter the Conference
Room number and press the OK Soft button to delete.