iPECS LIP-8012D - Leaving a Message Wait; External Calls; Placing External Co;Voip Calls

LIP-8012D & LIP-8024D User Guide
29
If you are the Attendant or Secretary, you may activate
Intrusion. You may also use Step Call; dial the next
station by dialing the last digit of the Intercom number.
4.1.2 Leaving a Message Wait
If the called user does not answer or is in DND mode,
you may leave a Message Wait. The called user will
receive a Message Wait indication; the message icon
will be displayed in the LIP-8024D. If the ring/message
LED is set to Message Wait Indication, the
ring/message LED will flash.
4.2 External Calls
4.2.1 Placing external CO/VoIP calls
External calls are placed on CO/IP lines. These ‘lines’
are accessed either using a button on the iPECS Phone
assigned as a CO/IP line or using dial codes. The
CO/IP lines are grouped for different types of calls, local,
long distance, etc. Using the CO/IP line group code,
you will be able to access any line from the group. A
Flex button on the iPECS Phone assigned as a LOOP
button lets you access a line from a group. Dial codes
for access to CO/IP lines are:
Individual CO/IP line access—
88 + Line number (01-42 for iPECS-100, or 001-
200 for iPECS-300 & 600).
or
88 + Line number (01-80 for iPECS-MG100, or
001-240 for iPECS-MG300).
To Camp-On (wait off-hook) for a busy station:
 Press * and await an answer.
To request a Callback (wait on-hook) for a busy station:
 Press the MSG button and hang-up.
To make a Voice Over announcement to a busy station:
 Dial #,
 After the Splash tone is heard, begin speaking.
To activate Message Waiting:
 Press the MSG button and hang-up.