3: SyStem CONFIGURAtION
36 Iridium Pilot User Manual
ELEMENT DESCRIPTION EXAMPLE
Localization Configures the localisation setting of the
ISU, takes an enumeration with one of the
following possible values:
“USA, Canada”
“UK, Ireland”
“Germany, France, Italy”
“Spain, Portugal”
China
Japan
Localisation “Germany, France, Italy”
Whitelist_Address_X Configures one of the 12 white listed IP
addresses, takes an IP address.
Whitelist_Address_1 123.456.789.123
Note: Configured white list addresses must be in a contiguous block starting with rule 1, otherwise
unexpected behaviour may occur. For example configuring addresses 1,2,3,4 would be fine, but configuring
1,2,8,9 would be wrong as would configuring rules 5,6,7.
Whitelist_Enable Enables or disables the use of the IP
address white list, takes and enumeration
of the format “enabled” or “disabled” as
input.
Whitelist_Enable disabled
Whitelist_Size Configures the number of configured
white listed IP addresses, takes an integer.
Whitelist_Size 4
Note: The size configured here must match the number of Whitelist_Address_X entries in the configuration
file otherwise unexpected behaviour may occur.
Compression_Mask Enables IP header compression, data
compression and the Performance
Enhancing Proxy (PEP), takes an integer.
This is a bit mask of the services to enable:
0x01 – IP header compression enabled
0x02 – ZLIB data compression enabled
0x04 – PEP enabled
Firmware_Notification Enables or disables the new firmware
available notification on the ISU’s
diagnostics web page, , takes and
enumeration of the format “enabled” or
“disabled” as input.
Firmware_Notification enabled
To Next Page
Loading...
