IROAD TR10 - Uninterrupted Fuse Cable

10. UNINTERRUPTED FUSE CABLE
It prevents battery discharge beforehand while in parking mode. The uninterrupted power function ensures your battery is protected.
The discharge of battery voltage will be prevented in advance for 24 hours if the battery level goes down the minimum preset level.
(There might be able to occur natural battery discharge caused by the long term parking hours or each vehicle status.
Please change voltage level up to high especially in winter season, refer to the instruction.)
Find the fuse to be installed using electric tester from fuse box of the vehicle.
[VCC]Line (Yellow Line): Make sure engine is off and connect to a current flowing fuse.
[ACC]Line (Red Line): Connect to fuse which should be not electric current.
Connect GND line to vehicle itself which has to connect iron part of vehicle itself.
Do not connect bolt of dash board where current is not flowing.
Connect the power cable to confirm the operation of product, and then neatly organize cables to finish installation work.
1
2
3
4
The colors of the VCC, ACC, and GND wires may change, so please check and install them.
Please do contact professional technician if you required any help on installation.
Please perform switching test (Driving mode <->Parking mode) before completing the installation.
Uninterrupted power function?
How to Install Uninterrupted Fuse Cable
+
1
2 3
10
15
10
10
20
20
15
15
10
10
10
15
10
15
10
10
20
4
The function is able to be changed for firmware upgrade or product enhancement without prior notice, please visit website regularly.