Isel ICP 3020 User Manual

ICP 3020 / ICP 4030 iMC-P Operating instruction
page 23
Impulse - interface impulse control, 8-pin connector
Use this connector to integrate the function keys start button, stop button and reset from the
controller front side as external signal inputs.
pin
description
1
input external START button (make contact)
2
+24VDC
3
input external STOP button (brake contact)
4
output lamp START button
5
GND
6
output lamp STOP button
7
input length measure switch
8
+24VDC
If the external STOP button is not used pins 2 and 3 must be bridged.
Input - digital inputs, 8-pin connector
The controller has 8 digital user inputs. Use these inputs to connect external devices like
sensors, switches or outputs from other devices. All inputs are opto-decoupled. If +24VDC
lies on the input a logical HIGH is signalized. Not connected (e.g. switch open) a logical
LOW is signalized.
Do not short 24VDC potential of the controller with GND or case
ground.
Use external emergency stop:
pin 5 and 6 bridged
pin 7 and 8 bridged
The length of the connection cable for the external emergency
stop button must not more than 5m.
Use external power button:
pin 1 and 2 bridged
connect external power button (make contact) on pin 3 and 4
In case of an emergency stop the +24VDC voltage on pin 4 is no
longer available.

Isel ICP 3020 Specifications

General

Brand	Isel
Model	ICP 3020
Category	Control Systems
Language	English