IsoMatic 500 - Safety instructions for fitting; Safety instructions for initial start-up and for operation; Safety instructions for using the hand transmitter; Approved safety equipment

10
TR10K009 RE / 02.2016
2.5 Safety instructions for fitting
The specialist carrying out the work must ensure that
installation is conducted in compliance with the prevailing
national job safety rules and regulations and those governing
the operation of electrical equipment. In the process, the
relevant national guidelines must be observed. Potential
hazards as outlined inEN13241-1 are avoided by
construction and fitting according to our guidelines.
The garage ceiling must guarantee secure fastening of the
operator. For ceilings which are too high or too light, the
operator must be fastened with additional struts.
DANGER
Risk of deadly electric shock from
mainsvoltage
▶
See warning in section3
WARNING
Unsuitable fixing material
▶
See warning in section3
Danger of injury due to unwanted door travel
▶
See warning in section3
CAUTION
Crushing hazard during boom fitting!
▶
See warning in section3
2.6 Safety instructions for initial start-up
andforoperation
WARNING
Danger of injury during door travel
If people or objects are in the area
around the door while the door is
inmotion, this can lead to injuries
ordamage.
▶
Make sure that children are not
playing near the door system.
▶
Make sure that no persons or
objects are in the door’s area
oftravel.
▶
If the door system has only one
safety feature, only operate the
garage door operator if you are
within sight of the door’s area
oftravel.
▶
Monitor the door travel until the
door has reached the end-of-travel
position.
▶
Only drive or pass through remote-
control door systems when the door
is at a standstill!
▶
Never stay standing under the
opendoor.
WARNING
Danger of injury due to a fast-closing door
▶
See warning in section8.2.1
CAUTION
Danger of crushing in the boom
Do not reach into the boom with your fingers during door
travel, as this can cause crushing.
▶
Do not reach into the boom during door travel.
CAUTION
Danger of injury from the cord knob
If you hang on the cord knob, you may fall and injure
yourself. The operator could break away and injure persons
or damage objects that are located underneath.
Theoperator could be destroyed.
▶
Do not hang on the cord knob with your body weight.
CAUTION
Danger of injuries due to the hot lamp
Touching the lamp during or immediately following operation
can lead to burns.
▶
Do not touch the lamp if it is switched on or was
recently switched on.
ATTENTION
If external voltage is applied, it will destroy
theelectronics.
External voltage on the connecting terminals of the control
will destroy the electronics.
▶
Do not apply any mains voltage (230 / 240VAC) to the
connecting terminals of the control.
2.7 Safety instructions for using the hand
transmitter
WARNING
Danger of injury due to unwanted door travel
▶
See warning in section6
CAUTION
Danger of injuries due to unintended door travel
▶
See warning in section6
2.8 Approved safety equipment
The following functions or components, where available, meet
cat. 2, PL “c” in accordance with EN ISO 13849-1:2008 and
were constructed and tested accordingly:
ō Internal power limit
ō Tested safety equipment
If such properties are needed for other functions or
components, this must be tested individually.
WARNING
Danger of injuries due to faulty safety equipment
▶
See warning in section5.1
ENGLISH