ITech IT6512C - Psc; Rst; SRE <N

IEEE-488 Commands
Copyright© Itech Electronics Co., Ltd. 112
Returns
<NR1>
*PSC
This command is used to control whether the power supply will generate a
service request when power on again.
 1 OR ON: When the power supply power on, status byte enable register,
operater event enable register, query event enable register and standard
event enable register will be cleared.
 0 OR OFF: When the power supply power on, The value of status byte
enable register, operater event enable register, query event enable register
and standard event enable register will be stored in the none-volatile
storage, which will be recalled when power on.
Command Syntax
*PSC <bool>
Parameters
0|1|ON|OFF
Query Syntax
*PSC？
Returned Parameters
0|1
*RST
This command reset the power supply to default settings.
Command syntax
*RST
Arguments
None
*SRE <n>
This command can set the parameter of state byte enable register.
Setting parameter can determine which byte value of state byte register
is 1 and the byte will set RQS of state byte register to 1. Bit definition of
state byte enable register is as the same as the state byte register.
Command syntax
*SRE <NRf>
Arguments
0～255