ITech IT6512C - Sequence[:Step]:Voltage; Sequence[:Step]:Current

Wave Operation Command
Copyright© Itech Electronics Co., Ltd. 66
Arguments
<1-10>
Example
SEQ:STEP:COUN 5
Query syntax
SEQuence:STEP:COUNt?
Returns
NR1
SEQuence[:STEP]:VOLTage
This command is used to edit the voltage of specified step of the wave file.
Command syntax
SEQuence[:STEP]:VOLTage <NR1>,<MINimum|MAXimum|NRf>
Arguments
<1-10>,MINimum|MAXimum|NRf
Unit
V
Example
SEQ:VOLT 6,7.0V
Query syntax
SEQuence[:STEP]:VOLTage？<NR1>,[MINimum|MAXimum]
Returns
NRf
SEQuence[:STEP]:CURRent
This command is used to edit the current of specified step of a wave file.
Command syntax
SEQuence[:STEP]:CURRent <NR1>,<MINimum|MAXimum|NRf>
Arguments
<1~10>,MINimum|MAXimum|NRf
Unit
A
Example
SEQ:CURR 1,12.0