Programming Codes iTherm
®
280 Programmer’s Guide
Page 106 Rev C 28-07764
[ESC] $ Cancel user-defined characters
ASCII [ESC] $
Hexadecimal 1BH 24H
Decimal <27> <36>
IPCL none
Description The [ESC] $ command removes all user-defined characters from the
printer’s memory. After the user-defined characters are canceled, the
internal character set is printed.
[ESC] > Enable user-defined characters
ASCII [ESC] > <n>
Hexadecimal 1BH 3EH <n>
Decimal <27> <62> <n>
Range <0>, <1>, 0, or 1
1 Enables the characters
0 Disables the characters
IPCL none
Description The [ESC] > <n> command enables or disables the user-defined
characters. The internal character set is printed.
To Next Page
Loading...
