Ithaca ITHERM 280 - Table 51 Character Pitch

iTherm
®
280 Programmer’s Guide ITherm® 280 Unicode and Fonts
28-07764 Rev C Page 279
NOTE: This is the minimum spacing. If the character height setting
requires a larger spacing, the character height will override this setting.
Function Set stroke font brush size. All
ASCII [ESC] + B <w>
Hexadecimal 1BH 2BH 42H
Decimal <27> <43> <66>
Range w = 0, 6 – 200
Description The [ESC] + B command will set brush stroke percentage for stroke fonts. If the
brush size is set to zero the font design stroke width will be used.
Values from 6 to 200 represent 0.4 to 12% of the em-width of the font. The default for most
fonts is about 3%. The ITherm 280 using the GB18030 font supplied by TransAct Technologies
produces the best characters with a brush size of about 100.
Note:
The default value for the Brush stroke may be set in the POR.INI file.
[ESC] [ P Set character pitch (Legacy mode command) PcOS
ASCII [ESC] [ P <n>
Hexadecimal 1BH 5BH 50H <n>
Decimal <27> <91> <80> <n>
IPCL &%F1, &%F2, &%F3, &%F4, &%F5, &%F6, &%F7
EPOS [ESC] [SP] <n>
Description The [ESC] [ P <n> command sets character per inch print pitch to <n>. The
printer resolution limits the exact print pitch. The following table lists the exact
pitch for various values on <n>.
<n> Resulting
Characters
per Inch
IPCL
1 1.00
2 2.00
3 3.01
4 4.00
5 4.95
6 5.94
7 6.93
8 8.00 &%F7
9 9.04
10 9.90 &%F3
11 10.95
12 12.23 &%F2
13 13.00
14 13.87
15 14.86 &%F6
<n> Resulting
Characters
per Inch
IPCL
16 16.00
17 17.33 &%F1
18 17.33
19 18.91
20 20.8 &%F5
21 20.8
22 23.11
23 23.11
24 23.11 &%F4
25 23.11
26 26
27 26
28 26
29 29.71
30 29.71
Table 51 Character Pitch