Programming Codes iTherm
®
280 Programmer’s Guide
Page 188 Rev C 28-07764
Supported TM-T90 Commands
Paper Sensor Commands
Command Name Page
ESC c 4 1BH,63H, 34H Select paper sensor(s) to stop printing. 203
ESC c 3 1BH,63H, 33H Select paper sensor(s) to output paper out
signals.
204
ESC c 1 1BH, 63H,
31H
Select paper types for command settings 217
ESC c 0 1BH, 63H,
30H
Select paper types for printing 216
Print Position Commands
Command Name Page
BS 08H Set back space 206
HT 09H Set horizontal tab positions 206
ESC $ 1BH,24H Set absolute print position 205
ESC < 1BH,3CH Return home 208
ESC D 1BH,44H Set horizontal tab positions 207
ESC Q 1BH,51H Set right margin in characters 208
ESC U 1BH,55H Turn on/off unidirectional printing mode 207
ESC \ 1BH,5CH Set relative print position 205
ESC a 1BH,61H Select justification 206
ESC l 1BH,6CH Set left right margin in characters 208
GS L 1DH,4CH Set left margin 207
GS T 1DH,54H Set print position to the beginning of the
line
205
GS W 1DH,57H Set printing area width 207
Bit-image Commands
Command Name Page
ESC * 1BH,2AH Select bit-image mode 209
GS v 0 1DH,76H,30H Print raster bit image 209
Status Commands
Command Name Page
DLE EOT 10H,04H Transmit real-time status 213
DLE ENQ 10H,05H Real-time status request to printer 227
ESC u 1BH, 75H Transmit peripheral status 214
ESC v 1BH, 76H Transmit paper status 215
GS a 1DH,61H Enable/disable automatic status back
(ASB)
210
GS r 1DH,72H Transmit status 212
To Next Page
Loading...
