iTherm
®
280 Programmer’s Guide Programming Codes
28-07764 Rev C Page 131
Function Define user-defined characters
ASCII [ESC] = <y> <c
1
> <c
2
> [x
1
d
1
… d(y x x
1
)] … [xk d
1
… d(y x xk)]
Second, save the definition in the nonvolatile flash memory with the appropriate
command.
Save the definition. Note the "Save user-defined characters" command saves all
three character definitions.
Function Save user-defined characters
ASCII [ESC] [US] c <Name..> <0>
Third, load the character set or load and run the macro.
To restore the character definitions, issue a load item command with the name of
the character set to be loaded.
The terminating <0> may be replaced with an & or redefined. See [ESC]
[EM]T<n> or &%UT<n> on page 136.
Function Load item from user store
ASCII [ESC] [US] l <Name..> <0>
If the item referenced is a user-defined character set, it is loaded into the current
definition. If it is a macro, it is loaded into the macro buffer. It is not processed or
printed.
To help maintain the user-store area, the following commands can be used.
The terminating <0> may be replaced with an & or redefined. See [ESC]
[EM]T<n> or &%UT<n> on page 136.
Function Flag as a start-up macro
ASCII [ESC] [US] s <Name..> <0>
The [ESC] [US] s <Name..> <0> command flags the referenced item to be
processed at startup. No more than one user character definition and user data
item may be flagged.
The terminating <0> may be replaced with an & or redefined. See [ESC]
[EM]T<n> or &%UT<n> on page 136.
Function Remove item from user store
ASCII [ESC] [US] e <Name..> <0>
The [ESC] [US] e <Name..> <0> command removes an item from user store and
frees up its space. The terminating <0> may be replaced with an & or redefined.
See [ESC] [EM]T<n> or &%UT<n> on page 136.
To Next Page
