6. Select Enter New Meter Model.
7. Select an existing meter model similar to the new meter as a template. Itron recommends
using the S-250 for an Intelis 250 gas meter and an S-250 TC for the Intelis 250 TC gas
meter. Select the green bar on the bottom of the screen to use the selected meter as the
starting point.
Note: Measurement Systems uses the lack of TC at the end of the meter name to
designate a non-TC meter, for example; an S-250 is an Itron I-250 CFH non-TC meter
and an Intelis 250 would designate an Intelis 250 CFH non-TC meter.
08 July 2020 815-0154-00 REV 000 Itron, Inc. Page 36 of 66
Intelis Gas Meter Proving and Setup Guide
5 Proving the Intelis Gas Meter Using the Measurement Systems
Proving System
To Next Page
Loading...
